1.It can Voltage, Current, Power and so on.
2.It can show Ah, Wh Capacity and Energy.
3.Load Resistance Measurement Shows The Equivalent Resistance
4.QC, FCP, PD monitoring (non-decoy)
5.Dual Voltage and Current Real-time Curve
Model: T50N Dual USB Tester
Display: 2.6 inch IPS TFT 320 * 240
Dimensions: 95 * 50 * 14mm
Sampling Resistance: 25 mΩ
Own Internal Resistance: 50 mΩ
Power Consumption: About 0.6W (120mA at 5V)
Fast Charge Trick: Don’t Support
D + D-Voltage: Not displayed
Voltage range: 3-25V (Independent Power Supply 0-25V)
Current Range: 0-5A
Resolution: 0.001V 0.001A
Accuracy: 0.03V 0.005A
1*USB-A male 2*Micro USB Mother 2*Type-C mother
2*USB-A Mother2*Type-C mother
1*Micro USB Female
1, The Bold Line represents the Power Line, take a large current, if 5A Circuit, make sure that Thick Line Part of the Circuit and the pad can withstand 5A Current for a long time.
2, Two ways common ground; Power can also be replaced by a road and can carry 2 loads.
3, 5V power supply available OUR supporting stepping plate steal electricity from 1, 3-25V can work.
4, Do not access PowerSupply V when IN1 is connected.
5, Because the power supply 5V is connected 1117 change 3.3V, and 5V direct access to the OP07, and these two devices in the following 10V can work properly, 5V then slightly higher point. Such as (6V), but be sure Stable, or OP07 at different voltage offset is not the same, leading to the need to recalibrate.
1 * USB Multimeter